Drug-Drug Interactions & Transporters

• 测试系统:转染细胞系表达ingle uptake (SLC) transporter or vector control, grown in monolayers in a humidified incubator at 37°C in 5% CO₂.
• Assay buffer: HBSS with HEPES, pH 7.4
• For MATE transporters only, cells are pretreated with NH₄Cl to introduce a pH gradient across the cell membrane, required for MATE uptake activity
• 测试浓度条2为底物测定s, 2 for inhibition assays
• Radioalabeled probe substrates specific for each transporter
• Positive control inhibitors for each transporter

Transporter-expressing cells in culture are preincubated with an assay buffer for 30 minutes in a humidified incubator at 37°C in 5% CO₂. MATE-expressing cells are treated with NH4CI to create a pH gradient across cell membrane to facilitate uptake activity. A probe substrate or test article is added to triplicate wells, and inhibitors are added where applicable. Plates are incubated for one time point from 2 - 10 minutes depending on the transporter. The buffer is aspirated; and cells are washed, then lysed, collected and analyzed for presence of the test article using LC-MS.

Substrate assessment: Uptake of the test article by each transporter alone or in the presence of selective inhibitor will be compared to uptake by the vector control after incubation for 2-5 minutes. Uptake of a probe substrate by each transporter alone or in the presence of selective inhibitor and by the vector control will be performed as controls.

Inhibitor assessment: Uptake of a probe substrate by each transporter will be conducted alone or in the presence of a selective inhibitor or the test article. Uptake of the probe substrate by the vector control will also be performed as a control. If inhibition is observed, the IC₅₀may be determined.

• Test system: Caco-2 human intestinal endothelial cells, cultured on Transwell plates in a humidified incubator at 37°C in 5% CO₂for 21- 24 days
• Assay buffer: HBSS with HEPES, pH 7.4 in both apical and basolateral chambers
• Transendothelial electrical resistance (TEER) is measured prior to assay to confirm the formation of tight junctions
• 测试浓度条2为底物测定s, 2 for inhibition assays
• Radiolabeled permeability markers mannitol and caffeine are used to verify tight junction formation
• Radiolabeled probe substrates are used, specific for each transporter
• Positive control selective inhibitors for each transporter with negative inhibitor controls

Apparent permeability of test article and probe substrates is determined in both the apical to basolateral (A-B) and basolateral to apical (B-A) directions on transwell plates. After 30 minutes of preincubation in an assay buffer in a humidified incubator at 37°C in 5% CO₂, the probe or test article is added to one chamber (donor) with a blank buffer in the opposite chamber (receiver). Inhibitors are then added to both chambers where applicable. Plates are incubated at 37°C in 5% CO₂for 2 hours. Donor and receiver chamber samples are collected and analyzed for presence of the test article using LC-MS. Then test article permeability and efflux ratio are determined.

Substrate assessment: The transport of the test article alone or in the presence of selective inhibitors will be determined in both directions. Transport of a probe substrate for each transporter alone or in the presence of selective inhibitors will be performed as controls.

抑制剂评价:探针substra运输te will be determined in both directions after incubation for 2 hours alone or in the presence of selective inhibitor or the test article. If inhibition of efflux transport is observed, the IC₅₀may be determined.

• Test system: Membrane vesicles (50 µg/well) expressing efflux (ABC) transporter BSEP.
• 测试浓度条2为底物测定s; 2 for inhibition assays.
• Adenosine triphosphate (ATP)-dependent activity measured, with adenosine monophosphate (AMP) used as control.
• Radiolabeled probe substrate specific for BSEP
• Positive control inhibitors for each transporter

Membrane vesicles expressing BSEP and the test article or probe substrate will be incubated in 96 well plates. Uptake will be initiated by the addition of adenosine triphosphate (ATP), followed by incubation for 30 minutes at 37°C. Adenosine monophosphate (AMP) will be used in parallel as a negative control. The uptake will be terminated by vacuum aspiration and rinsing the filters twice with excess ice‑cold transport buffer. Vesicles are then extracted from filter plates for LC‑MS quantitation and calculation of ATP-dependent activity.

Substrate assessment: Uptake of the test article alone and with selective inhibitor in the presence of ATP will be compared to uptake in the presence of AMP. Uptake of a probe substrate by BSEP alone and in the presence of selective inhibitor will be performed as controls.

Inhibitor assessment: Uptake of a probe substrate will be conducted alone and in the presence of selective inhibitor or the test article; uptake in the presence of ATP will be compared to uptake in the presence of AMP. If inhibition of ATP-dependent uptake of the test article is observed, the IC₅₀may be determined.